Ads
related to: engine block jumper cable adapter home depot tool rental
Search results
Results From The WOW.Com Content Network
Jump starting a vehicle. Crocodile clips, also called automotive clips, on a set of jumper cables. A jump start, also called a boost, is a procedure of starting a motor vehicle (most commonly cars or trucks) that has a discharged battery. A temporary connection is made to the battery of another vehicle, or to some other external power source.
Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)
The clamps have 100-percent copper jaws for maximum conductivity, and they securely connect to both top- and side-post batteries. The Autogen BC-1G30 cables come with a pair of gloves and portable ...
It can also backfeed power into the grid, potentially damaging utility equipment or even electrocuting linemen attempting to restore power. Similarly, an exposed connection on a jumper cable for a 12V automotive battery can be hazardous, because of the potentially high current and energy involved. Accidental shorting of the wire to vehicle ...
Punch-down block. A split-50 M-type 66 block with bridging clips attached. A 110 punch-down block. A punch-down block (also punchdown block, punch block, punchblock, quick-connect block and other variations) is a type of electrical connection often used in telephony. It is named because the solid copper wires are "punched down" into short open ...
Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping. [citation needed]
Punch down tool. A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks, patch panels, keystone modules, and surface mount boxes ...
Ads
related to: engine block jumper cable adapter home depot tool rental