Search results
Results From The WOW.Com Content Network
Trickle charging. Trickle charging means charging a fully charged battery at a rate equal to its self-discharge rate, thus enabling the battery to remain at its fully charged level; this state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.
Battery balancing and battery redistribution refer to techniques that improve the available capacity of a battery pack with multiple cells (usually in series) and increase each cell's longevity. [1] A battery balancer or battery regulator is an electrical device in a battery pack that performs battery balancing. [2]
A battery management system (BMS) is any electronic system that manages a rechargeable battery (cell or battery pack) by facilitating the safe usage and a long life of the battery in practical scenarios while monitoring and estimating its various states (such as SoH, and SoC), [1] calculating secondary data, reporting that data, controlling its environment, authenticating or balancing it. [2]
Rechargeable battery. A battery bank used for an uninterruptible power supply in a data center. A rechargeable lithium polymer mobile phone battery. A common consumer battery charger for rechargeable AA and AAA batteries. A rechargeable battery, storage battery, or secondary cell (formally a type of energy accumulator ), is a type of electrical ...
A mobile phone plugged in to an AC adapter for charging. A battery charger, recharger, or simply charger, [ 1][ 2] is a device that stores energy in an electric battery by running current through it. The charging protocol—how much voltage, current, for how long and what to do when charging is complete—depends on the size and type of the ...
Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. [1] The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger. [2]
Nickel–zinc batteries have a charge–discharge curve similar to 1.2 V NiCd or NiMH cells, but with a higher 1.6 V nominal voltage. [5]Nickel–zinc batteries perform well in high-drain applications, and may have the potential to replace lead–acid batteries because of their higher energy-to-mass ratio and higher power-to-mass ratio – as little as 25% of the mass for the same power. [6]
IUoU is a DIN -designation [1] (DIN 41773) for a lead-acid battery charging procedure that is also known as 3-stage charging, 3-phase charging, or 3-step charging. It consists of three phases (or stages), to be executed by a battery charger. The three phases are: I-phase (constant electric current ), Uo-phase (constant over- voltage ), and U ...