Search results
Results From The WOW.Com Content Network
The "Utilization category" are mainly categorized in IEC 60947 in the following volume: Volume 1: General requirements. Volume 2: Circuit-breakers. Volume 3: Circuit-breakers, circuit-breakers, switch-disconnectors and switch-fuse units. Volume 4-1: Contactors and motor starters; electromechanical contactors and motor starters [1]
Switched reluctance motor with magnetic flux lines. The switched reluctance motor ( SRM) is a type of reluctance motor. Unlike brushed DC motors, power is delivered to windings in the stator (case) rather than the rotor. This simplifies mechanical design because power does not have to be delivered to the moving rotor, which eliminates the need ...
A switched-mode power supply ( SMPS ), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently. Like other power supplies, an SMPS transfers power from a DC or AC source (often mains ...
Inrush current. Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.
A reluctance motor is a type of electric motor that induces non-permanent magnetic poles on the ferromagnetic rotor. The rotor does not have any windings. It generates torque through magnetic reluctance . Reluctance motor subtypes include synchronous, variable, switched and variable stepping. Reluctance motors can deliver high power density at ...
In a recent study, published in The Journal of Neuroscience, researchers adopted a novel approach to dyskinesia by treating it as a “bad motor memory.”. They discovered that inhibiting a ...
A flyback diode is any diode connected across an inductor used to eliminate flyback, which is the sudden voltage spike seen across an inductive load when its supply current is suddenly reduced or interrupted. It is used in circuits in which inductive loads are controlled by switches, and in switching power supplies and inverters .
H-bridge. An H-bridge is an electronic circuit that switches the polarity of a voltage applied to a load. These circuits are often used in robotics and other applications to allow DC motors to run forwards or backwards. [1] The name is derived from its common schematic diagram representation, with four switching elements configured as the ...