Search results
Results From The WOW.Com Content Network
As a whole, ground bounce is a major issue in nanometer range technologies in VLSI. Ground bounce can also occur when the circuit board has poorly designed ground paths. Improper ground or V CC can lead to local variations in the ground level between various components. This is most commonly seen in circuit boards that have ground and V CC ...
A soft-switching three-level inverter (S3L inverter) is a high-efficiency power electronic inverter intended, in particular, for use with three-phase drives, as a grid-tie inverter for photovoltaic installations or wind turbines and in power supplies. [1] The topology was developed in 2009 at HTWG Konstanz (Constance University of Applied ...
Switching circuit theory is the mathematical study of the properties of networks of idealized switches. Such networks may be strictly combinational logic, in which their output state is only a function of the present state of their inputs; or may also contain sequential elements, where the present state depends on the present state and past states; in that sense, sequential circuits are said ...
Push–pull output. A push–pull amplifier is a type of electronic circuit that uses a pair of active devices that alternately supply current to, or absorb current from, a connected load. This kind of amplifier can enhance both the load capacity and switching speed.
The "Utilization category" are mainly categorized in IEC 60947 in the following volume: Volume 1: General requirements. Volume 2: Circuit-breakers. Volume 3: Circuit-breakers, circuit-breakers, switch-disconnectors and switch-fuse units. Volume 4-1: Contactors and motor starters; electromechanical contactors and motor starters [1]
A silicon controlled rectifier or semiconductor controlled rectifier is a four-layer solid-state current -controlling device. The name "silicon controlled rectifier" is General Electric 's trade name for a type of thyristor. The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell ...
Power amplifier circuits (output stages) are classified as A, B, AB and C for linear designs—and class D and E for switching designs. The classes are generally based on the proportion of each input cycle (conduction angle) during which an amplifying device passes current.
An inrush current limiter is a component used to limit inrush current to avoid gradual damage to components and avoid blowing fuses or tripping circuit breakers. Negative temperature coefficient (NTC) thermistors and fixed resistors are often used to limit inrush current. NTC thermistors can be used as inrush-current limiting devices in power ...